H/P
-
-
-
Apeks HP Splitter
The Apeks HP twin adaptor allows you to use both a submersible pressure gauge and a transmitter from a first stage that only has a single high pressure port.
The twin adaptor also has the added benefit of allowing the transmitter to rotate 360 degrees, which prevents the transmitter being damaged if a cylinder was to fall over.
The Apeks HP twin adaptor utilises a standard 7/16” thread and is suitable for use on all manufacturers first stages.
-
Din To Yoke Adaptor (A Clamp) Aqualung
The Aqua Lung DIN-to-Yoke Converter will allow a DIN First Stage regulator to be mounted on a cylinder with a standard yoke style valve. For the diver traveling with a DIN first stage, it is a critical accessory.
-
HP Port Adaptor AC906
Use this to add an additional high pressure port to your regulator’s first stage
Chromed brass construction with Viton O-rings
High pressure only - maximum 340 bar
Cleaned for use with up to 40% pre-blended Nitrox
(1) 7/16”-20 male inlet to (2) 7/16”-20 female outlets
-
-
Port Adaptor AC940
Add to any pressure gauge, console or air integrated console which uses a standard high pressure hose
Remove your gauges for safe storage
Bayonet mount style quick-connect (push in and turn)
Gauge attachment end has 7/16”-20 female threads
Hose attachment end has 7/16”-20 male threads
Airspool with Viton O-rings included
Brass construction with black chrome finish
Cleaned for use with up to 40% pre-blended Nitrox
-
Quick Disconnect Hp AC383
Add to any pressure gauge, console or air integrated console which uses a standard high pressure hose
Remove your gauges for safe storage
Bayonet mount style quick-connect (push in and turn)
Gauge attachment end has 7/16”-20 female threads
Hose attachment end has 7/16”-20 male threads
Airspool with Viton O-rings included
Brass construction with black chrome finish
Cleaned for use with up to 40% pre-blended Nitrox