Peli 0350 Protector Case With Foam
Sensitive equipment needs protection, and since 1976 the answer has been the Peli™ Protector Case. These cases are designed rugged, and travel the harshest environments on earth. Against the extreme cold of the arctic or the heat of battle, Peli cases have survived.
Made in the USA, these tough cases are designed with an automatic purge valve, that equalizes air pressure, a watertight silicone O-ring lid, over-molded rubber handles and stainless steel hardware.
- Large 2-person fold down handles
- Watertight, crushproof, and dustproof
- Open cell core with solid wall design - strong, light weight
- 3 level Pick N Pluck™ with convoluted lid foam
- Stainless steel hardware and padlock protectors
- Automatic Pressure Equalization Valve - balances interior pressure, keeps water out
- Peli's legendary lifetime guarantee**
- O-ring seal
- * Where applicable by law
- TMAll trademarks are registered and/or unregistered trademarks of Peli Products, S.L.U., its parent, subsidiaries and/or affiliates.
Dimensions
Interior (L×W×D)
50.8 x 50.8 x 50.8 cm
Exterior (L×W×D)
57.2 x 57 x 54 cm
Measurements
Lid Depth
12.7 cm
Bottom Depth
38.1 cm
Total Depth
50.8 cm
Int Volume
0.131 m³
Padlock Hole Diameter
0.8 cm
Weights
Weight With Foam
14.5 kg
Weight Empty
11.8 kg
Buoyancy
122 kg
Materials
Body Material
Polypropylene
Latch Material
ABS
O-Ring Material
Polymer
Pins Material
Stainless Steel
Foam Material
1.3 lb Polyurethane
Purge Body Material
ABS
Purge Vent Material
3 Micron Hydrophobic Non-Woven
Temperatures
Minimum Temperature
-40° F (-40 ° C)
Maximum Temperature
210° F (99 ° C)
Approvals
Certifications
IP67 / Def Stan 81-41
